PVC shrink film Printing Inks - Heat Shrink PVC film Printing Inks Manufacturer & Exporter

PVC shrink film Printing Inks

We specialize in manufacturing and offering unmatched quality two pack ultra gloss ARS prominent printing on treated multilayer films for oil pouches in single pack system as well as in two pack system. The assortment is also appreciated for high print density and excellent adhesion properties by our clients.

Heat Shrink PVC film Printing Inks

Multi Gloss Gravure Surface Printing Concentrated Poly Inks Based on NC & Polyamide Resin for treated Polyethylene, Polyproplyene PVC and wide range of Olefinic substrates.

Gravure Surface Printing Concentrated Poly Inks Based on NC & Polyamide Resin are designed for surface printing on Gravure machines with cylinders.

Features: -

Excellent Printability
High Gloss
High Strength
Good Tape release
Good Scuff resistance

Good Crinkle resistance After addition of Hardners @ 5% at the time of printing, good alkali resistance, good adhesion and soap resistance is obtained. Hence our A.R inks after addition of Hardners are suitable for detergent pack printing.

Recommended Application:-

For high quality, Tonal printing and fine line printing at high speed on Polyethylene Film.

Substrates: -

Can be printed on all types of Polyethylene, Polyproplyene, PVC, PT, MST.
For Polythylene and Polyproplyene film the treatment should be 38 dynes per / cm for good adhesion and optimum resistance properties.

Printability: -

Excellent printability in Half Tone and good coverage in Full Tone.
Free from any printing defects such as streaking and scumming etc.
Excellent rub and scratch resistance.

Diluents: -

The inks have a tolerance with a wide range of solvents to accommodate variation in press speed and conditions.

For Flexo: -

The usual diluent for Flexo inks is a blend of Isopropyl Alcohol and Butyl Alcohol. Ink makers recommendation should be followed in order to get the best printing and optimum drying under various conditions.

For Gravure: -

Recommended diluents are Toluene or blend of Isopropyl Alcohol, Butyl Alcohol is recommended as Retarded.

Colour Range: -

Full range of Pantone basic shades including Metallic and ARSR and Light Fast Shades.

Grinding :

Less than 0.5 MICRONS
% age Solids : 45 + 2
LIGHT FASTNESS : Fair to good.
HEAT RESISTANCE : 1500 –2000 C
OPACITY / TRANSPERACY : Depending on colours to colour.
GLOSS : Good
DRYING TIME : The process is Air drying at Room temperature within seconds.
PECIFIC GRAVITY : White Ink : 1.100-1.1500 g/cubic cm, Colour Ink:0.880-0.970 g/cubic cm at 20 degrees Celsius.
COLOR REDUCTION : CHEMICOAT Poly Medium

STORAGE & SAFETY :

1. Use the recommended thinner only.
2. Stir well before using, as phase separation may occur over time.
3. To keep away from Heat.

REDUCTION SOLVENTS :

Is a blend of Toluene & Iso-Propyl Alcohol. Reduction of Gravure Concentrated Poly inks in the ratio of 1:1 as under :

Understirrer :

Concentrated Ink : 1 Part
Poly Medium : 1 Part
Blend of IPA & Toluene : 1 Part
Total : 3 Part

The information in this data sheet has been carefully complied from our experience gained and detailed laboratory testing. However, the product performance and its suitability for the customers purpose depend on the particular condition of use and the material printed. We recommended that the customer satisfy themselves that each product meets their requirement in all respects before commencing a print run.

Send Enquiry